If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
cutting cylinders
Hi,
I am trying to cut a series of identical cylindrical forms ( quartz, lapis lazuli), plusminus 5 to 8 mm thick, 25 mm long. I have got a Lortone cabbing machine with a diamond ( 180 )wheel.I find it very difficult to cut a symmetrical cylinder just by hand. Anyone got some ideas to help me ? Michiel |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
cutting circles out of glass - tips ? | Adrian Brentnall | Glass | 13 | April 15th 04 09:42 PM |
Advice needed -- Cutting Narrow Strips | Joe Cahill | Glass | 3 | September 18th 03 05:19 PM |
Microscope Slide - Glass Cutting Jig | MaryJLind | Beads | 6 | September 10th 03 02:03 PM |
cutting glass into thin sections | jad_23 | Glass | 8 | August 9th 03 03:51 PM |
cutting softflex | LiisaAnn | Beads | 1 | July 8th 03 08:42 PM |