If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
annealing brass
Could someone help me out, please. I'm trying to anneal brass but it's
turning copper color in the pickle. I put a piece of silver wire in to see if the pickle is bad and plating it with copper. No changes to the silver yet. Most of what I've read about annealing just says to heat until it is dull red and I've done this with silver. Is there a different procedure for brass and other metals? Thanks, CR |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Drilling brass? | C Ryman | Jewelry | 16 | February 26th 05 02:47 AM |
Brass shim in wearable piece | Rick Cook | Jewelry | 0 | September 11th 04 04:15 AM |
Use of Brass Coated Lead Came | Gloria | Glass | 3 | August 19th 03 05:26 AM |
Nickel plated brass needles | AGRES | Yarn | 0 | July 24th 03 09:59 PM |
Technical questions on etching and annealing | D Brock | Glass | 0 | July 1st 03 05:32 PM |