If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Loctite 330 Adhesive
Hello,
I was wondering if anyone has experience of using Loctite 330 adhesive? My particular application is gluing gold to ivory. I have had a couple of bad experiences with joints coming apart after using Araldite, both normal cure and "rapid". I originally thought it was due to over stressing a small joint area but now believe the joint fails due to the friction heat from abrasive paper. Loctite 330 has been recommended but I have no experience of that adhesive. Any information, help or advice would be greatly appreciated. Thanks, Cameron |
Ads |
#2
|
|||
|
|||
Cameron Robb wrote:
Hello, I was wondering if anyone has experience of using Loctite 330 adhesive? My particular application is gluing gold to ivory. I have had a couple of bad experiences with joints coming apart after using Araldite, both normal cure and "rapid". I originally thought it was due to over stressing a small joint area but now believe the joint fails due to the friction heat from abrasive paper. Loctite 330 has been recommended but I have no experience of that adhesive. Any information, help or advice would be greatly appreciated. Thanks, Cameron http://www.loctite.com/ Abrasha http://www.abrasha.com |
#3
|
|||
|
|||
I've used Loctite to give added security to screw type fastners/findings,
especially hand made. Something about the way I move makes them come apart as I wear them, sending the pendant etc flying. I fear the same happening to jewelery I've sold, so add a drop to the screw thread for piece of mind. So far I've not had any problems with it. -- Marisa (AU/NZ) "Cameron Robb" wrote in message ... Hello, I was wondering if anyone has experience of using Loctite 330 adhesive? My particular application is gluing gold to ivory. I have had a couple of bad experiences with joints coming apart after using Araldite, both normal cure and "rapid". I originally thought it was due to over stressing a small joint area but now believe the joint fails due to the friction heat from abrasive paper. Loctite 330 has been recommended but I have no experience of that adhesive. Any information, help or advice would be greatly appreciated. Thanks, Cameron |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EARRINGS, WHAT ADHESIVE DO YOU USE? | Rick Frazier | Glass | 12 | July 10th 04 09:36 PM |
BEST ADHESIVE | COSMO | Beads | 10 | November 26th 03 05:02 PM |