If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
|
Ads |
#2
|
|||
|
|||
suggestions for type of foam?
Can anyone suggest a type/vendor for lightweight cylindrical foam,
desired diameter approximately 1.5-2" and length 4-6'? Looking for something resistant to water -- non-absorbent, light, and stiff (negligable to no bending under own weight at 4-5 feet length). Looking for something reasonably sturdy -- something that can withstand about 8-10 pounds hung mid-point between a 4' cylinder that is supported at both ends horizontally. This is for a science project. Thanks for any suggestions!!! -- Paul Allen |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Suggestions needed for tinting glass | Ron | Glass | 2 | January 5th 05 12:11 AM |
Suggestions for photo | JoAnn Paules | Beads | 0 | August 23rd 04 10:03 PM |
Watch Band suggestions? | Marisa Exter | Beads | 10 | April 14th 04 06:40 AM |
[OT] Suggestions? | Cheryl | Beads | 7 | September 17th 03 09:35 PM |
"Removable" decoupage panel suggestions?... | Steven | General Crafting | 2 | August 31st 03 12:57 AM |