|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 14th 04, 11:01 PM
|
|||
|
|||
Is it possible to carve nitroglycerine ? ? ? ? ?
I want to carve nice objects from nitroglycerine.
What should I do? 
|
| Ads |
|
#2
December 15th 04, 05:05 AM
|
|||
|
|||
|
On 14 Dec 2004 15:01:10 -0800,
(Bruno Beam) wrote: I want to carve nice objects from nitroglycerine. What should I do? The best way for you would be to form it up by striking your material sharply with hammer blows.
|
|
#3
December 15th 04, 05:07 PM
|
|||
|
|||
|
Only ONE hammer blow will be necessary.
-- Charley "hue" wrote in message ... On 14 Dec 2004 15:01:10 -0800, (Bruno Beam) wrote: I want to carve nice objects from nitroglycerine. What should I do? The best way for you would be to form it up by striking your material sharply with hammer blows.
|
|
#4
December 20th 04, 01:29 PM
|
|||
|
|||
|
Be sure to wear suitable ear protection!
"Bruno Beam" wrote in message om... I want to carve nice objects from nitroglycerine. What should I do?
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can I carve Thorium ? ? ? ? | Hans-Marc Olsen | Carving | 2 | July 26th 05 12:06 AM |
| I carve air ! | Brian Raab | Carving | 0 | October 3rd 04 02:51 AM |
| Carve on oak whiskey barrel tops? | kyrustic | Carving | 0 | February 24th 04 12:05 AM |
| How to carve bones? | Shane D. Maudiss | Carving | 6 | December 6th 03 04:40 PM |
Linear Mode
