If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Two Strand Toggle Problems
My wife is putting out a line of watch bracelets using beads, watch
faces of course, two hole toggles and .018 Beadalon wire. My wife does the designing and beading and I do the finishing work, eg., attaching the two hole toggles with crimp tubes and putting on the crimp covers. Most of the time things go just fine but about a quarter of the time, the wire gets a twist into it which puts a twist into the entire half of the beaded bracelet. If the twist it too noticable, it has to be restrung and recrimped until it goes together without the twist. Has anybody else run into this sort of problem and how did they manage to work around it. Thank you, Bob |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
LOVE THE TOGGLE | Beckibead | Beads | 4 | November 28th 06 09:24 PM |
Source for JUST toggle bars? | JeanneP | Beads | 3 | October 6th 06 03:47 PM |
AD: Very Small Toggle Clasps That I Can't Use | ang | Beads | 2 | November 10th 04 05:52 AM |
Thread and toggle frustration | Gemfyre | Beads | 11 | June 9th 04 02:51 AM |
Lampwork Toggle | MargieK | Beads | 5 | October 20th 03 11:02 PM |