If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Stencil or stamp?
wrote in message ... Hi all, I have much experience in making printed circuit boards using photoetching techniques. Recently I got 10 Kgs of epoxy glass copper clad boards, double sided, from a friend that quitted his electronics activity. My past experiences with photoetching have been a great success if I used already-photoresist-coated boards, and a total failure when I tried to apply photoresist via a spray on non photoresist-coated boards (like those 10 Kg of epoxy glass I recently got). So I wanted to use a different system for these uncoated epoxy glass copper boards. So far I'm imagining two possible solutions: 1) make stencils, and then spray a normal acid-resistant varnish through its "holes". 2) make stamps, and apply them on the epoxy glass to put a strate of ink where necessary (will it be thick enough?) I need to produce really fine detail, like 0.2 mm lines (surface mount devices), and these lines must not have any breaks in them, because that would mean an electrical connection break. What would be the best path to follow, stencils or stamps? I would prefer stamps, ideally. And, then, what would be the best way to make such a high resolution stamps or stencils? Thanks! Giovanni You might want to try posting this question on sci.electronics.basic or sci.electronics.design as you may get more answers over there Larry |
Ads |
#2
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HOW RUBBER STAMPS ARE MADE & how i made $$$ - I AM SELLING MY MACHINE AND METAL SHEETS | Nintendo DS 4 Sale | Rubberstamps | 3 | November 28th 04 01:28 PM |
Stencil or stamp? | [email protected] | Rubberstamps | 0 | December 6th 03 10:17 AM |
AD: Stampola Newsletter (Sept) | Mindy at Stampola | Rubberstamps | 0 | September 29th 03 04:49 PM |
AD - Stampola September Newsletter | Chris | General Crafting | 0 | September 28th 03 05:08 PM |