If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
seal watch parts into jewelry
I'm experimenting with 'steampunk' look jewelry and wanted to create a
design on a 316 steel pendant or ring. After I set the tiny pocke****ch parts in place, what do you recommend to clear seal and protect them? I thought about epoxy, but what about marine varnish or wood floor sealer. Obviously, the harder and more scratch resistant (especially for the ring) the better. Thanks! Ben |
Ads |
#2
|
|||
|
|||
Hi I'm new to this forum and i don't have an idea regarding this ...Sorry ...Hope you get solution from someone else ...Thank you ...
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Monterrey Medallion parts is parts | Batik Freak | Quilting | 17 | March 26th 06 10:57 PM |
Jewelry diamond and watch Information | Gemlogix | Jewelry | 0 | March 29th 05 03:41 AM |