If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Soldering
I have been soldering since about 10 years old but pretty much confined to a
soldering iron. The problems of attaching gem heads with a torch seem a bit daunting. My current project is to be-jewel a silver chalice with my faceted and cabbed stones. On my practice goblet, I have been using Crazy Glue with no problems other than the fact that they would probably all fall off if I dropped it. Could someone point me to some basics on soldering with a torch? I have silver bearing solder that can be melted with a hot iron but getting the base hot enough to wet is a bit of a problem. js -- PHOTO OF THE WEEK: http://schmidling.netfirms.com/weekly.htm Astronomy, Beer, Cheese, Gems, Sausage, http://schmidling.netfirms.com |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Silver Soldering | Jack Ouzzi | Jewelry | 3 | March 28th 04 05:33 PM |
Soldering Jump Rings | Raane | Jewelry | 10 | March 16th 04 04:28 PM |
Soldering iron tip | Craig | Glass | 2 | February 19th 04 06:32 PM |
soldering gun/iron recommendations? | Jennifer Moore | Beads | 17 | December 6th 03 01:43 AM |
Soldering copper mounting brackets. | Andy Dingley | Glass | 1 | November 27th 03 11:28 PM |