|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 4th 03, 03:22 AM
|
|||
|
|||
help - terminology and factors
Ok, just got my Wild Ginger software in. Its asking for a couple of setting
I'm not sure of. One is facing width. I'm doing a coat. What's an adequate setting? 1.5 inches? 2 inches. The other is hem allowance. What would that be, about 1 inch? 1.5 inches? 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode