|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 17th 07, 05:12 AM
posted to rec.crafts.pottery
|
|||
|
|||
Venturi burners
I've spent some time building raku and cone10 gas fired kilns. In my never
ending quest for finding venturi burners that are versatile and don't cost an arm and a leg, I located a simple venturi that accepts 3/4 pipe. If anyone is interested here is the webaddress for the store where i found it. http://www.tejassmokers.com/castironburners.htm Graham 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Critical Dimensions For Mixing Venturi? | The Lightning Stalker | Pottery | 3 | January 6th 07 05:01 AM |
| Critical Dimensions For Mixing Venturi? | The Lightning Stalker | Glass | 12 | December 17th 06 04:43 AM |
| Propane gas burners | [email protected] | Pottery | 3 | March 20th 06 05:07 AM |
| Pressurized Kerosene kiln burners | Mark Holden | Pottery | 0 | September 9th 05 04:04 PM |
Linear Mode
