![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I have an exceptional piece of lapis, that I want to cut. My trim saw uses oil
to cut with. Will oil harm this gemstone? |
Ads |
#2
|
|||
|
|||
![]()
Hi,
I have an exceptional piece of lapis, that I want to cut. My trim saw uses oil to cut with. Will oil harm this gemstone? If I were you, I'd drain the oil from the saw & use water to cut the lapis. Lapis is a relatively soft material & water will work fine for keeping the saw cool & clearing the swarf. If oil is used, the lapis may absorb enough of it to affect it's appearance. You may also need to leave the lapis in kitty litter or whatever you use to absorb the oil for a much longer period of time than a stone like quartz. Dave |
#3
|
|||
|
|||
![]()
I have an exceptional piece of lapis, that I want to cut. My trim saw uses
oil to cut with. Will oil harm this gemstone? I was taught to use water instead of oil with Lapis but I can't find any references saying exactly why. I seem to remember that the oil would discolor the stone. Water works just fine so I never bothered to experiment. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Glass cutting lubricant | Charles A. Peavey | Glass | 22 | November 7th 03 07:55 PM |
Advice needed -- Cutting Narrow Strips | Joe Cahill | Glass | 3 | September 18th 03 05:19 PM |
Microscope Slide - Glass Cutting Jig | MaryJLind | Beads | 6 | September 10th 03 02:03 PM |
cutting glass into thin sections | jad_23 | Glass | 8 | August 9th 03 03:51 PM |
cutting softflex | LiisaAnn | Beads | 1 | July 8th 03 08:42 PM |