If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Revive a dead dinner bell!??
I have an old, very ornately painted (glazed) dinner bell my Mom made
probably 70 years ago or more. When I was a kid, it had a beautiful ring to it but haven't heard it since. Currently it has a sad "tink" sound to it. The inside "dinger" is not glazed and I don't know how to tell if it's been fired. It's about 4 inches tall and it's bottom diameter is about 3 inches. It's walls are probably 3/16 inches thick. I can see the glaze is very discolored probably by kitchen oils, etc. over time and I'm guessing this is what deadened the ring. Is there any way to put this little dinner bell back to work? Many thanks, Andy P.S. If it rings again, I'll post a quicktime (movie) of it on my website upon request. --A -- "Ladies and gentlemen, The Beatles!" - Ed Sullivan (1964) |
Ads |
#2
|
|||
|
|||
i'd leave it as is, put away somewhere safe. it has it's story & grew
older & more quiet like most of us. but unless you know the clay body - high temp or low temp - or the finish, enamel or glaze, you don't know if a re-fire will fix or erase everything. see ya steve |
#3
|
|||
|
|||
"Andy" wrote in message 6... I have an old, very ornately painted (glazed) dinner bell my Mom made probably 70 years ago or more. When I was a kid, it had a beautiful ring to it but haven't heard it since. Currently it has a sad "tink" sound to it. The inside "dinger" is not glazed and I don't know how to tell if it's been fired. It's about 4 inches tall and it's bottom diameter is about 3 inches. It's walls are probably 3/16 inches thick. I can see the glaze is very discolored probably by kitchen oils, etc. over time and I'm guessing this is what deadened the ring. Is there any way to put this little dinner bell back to work? Have you checked for cracks in the ringer and the bell? I would think that would have an effect on the sound. Marianne |
#4
|
|||
|
|||
"Bubbles" wrote in
: "Andy" wrote in message 6... I have an old, very ornately painted (glazed) dinner bell my Mom made probably 70 years ago or more. When I was a kid, it had a beautiful ring to it but haven't heard it since. Currently it has a sad "tink" sound to it. The inside "dinger" is not glazed and I don't know how to tell if it's been fired. It's about 4 inches tall and it's bottom diameter is about 3 inches. It's walls are probably 3/16 inches thick. I can see the glaze is very discolored probably by kitchen oils, etc. over time and I'm guessing this is what deadened the ring. Is there any way to put this little dinner bell back to work? Have you checked for cracks in the ringer and the bell? I would think that would have an effect on the sound. Marianne Marianne, I just checked with the naked eye and fingers. The eye's can't tell and it's too rough for the fingers to tell. Thanks, Andy -- "Ladies and gentlemen, The Beatles!" - Ed Sullivan (1964) |
#5
|
|||
|
|||
"Andy" wrote in message 6... "Bubbles" wrote in : "Andy" wrote in message 6... I have an old, very ornately painted (glazed) dinner bell my Mom made probably 70 years ago or more. When I was a kid, it had a beautiful ring to it but haven't heard it since. Currently it has a sad "tink" sound to it. The inside "dinger" is not glazed and I don't know how to tell if it's been fired. It's about 4 inches tall and it's bottom diameter is about 3 inches. It's walls are probably 3/16 inches thick. I can see the glaze is very discolored probably by kitchen oils, etc. over time and I'm guessing this is what deadened the ring. Is there any way to put this little dinner bell back to work? Have you checked for cracks in the ringer and the bell? I would think that would have an effect on the sound. Marianne Marianne, I just checked with the naked eye and fingers. The eye's can't tell and it's too rough for the fingers to tell. Thanks, Andy I agree with both Steve and Marianne. Its probably cracked, but its worth keeping just the way it is. If you try to refire it you will almost certainly damage it. I think just value it for its history ) Annemarie |
#6
|
|||
|
|||
"annemarie" wrote in
: "Andy" wrote in message 6... "Bubbles" wrote in : "Andy" wrote in message 6... I have an old, very ornately painted (glazed) dinner bell my Mom made probably 70 years ago or more. When I was a kid, it had a beautiful ring to it but haven't heard it since. Currently it has a sad "tink" sound to it. The inside "dinger" is not glazed and I don't know how to tell if it's been fired. It's about 4 inches tall and it's bottom diameter is about 3 inches. It's walls are probably 3/16 inches thick. I can see the glaze is very discolored probably by kitchen oils, etc. over time and I'm guessing this is what deadened the ring. Is there any way to put this little dinner bell back to work? Have you checked for cracks in the ringer and the bell? I would think that would have an effect on the sound. Marianne Marianne, I just checked with the naked eye and fingers. The eye's can't tell and it's too rough for the fingers to tell. Thanks, Andy I agree with both Steve and Marianne. Its probably cracked, but its worth keeping just the way it is. If you try to refire it you will almost certainly damage it. I think just value it for its history ) Annemarie OK, but OT, is there some connection between Marianne and Annemarie? The co-incidence is hard not to notice. Thank you for your advice, Andy -- "Ladies and gentlemen, The Beatles!" - Ed Sullivan (1964) |
#7
|
|||
|
|||
"Andy" wrote in message 6... "annemarie" wrote in : "Andy" wrote in message 6... "Bubbles" wrote in : "Andy" wrote in message 6... I have an old, very ornately painted (glazed) dinner bell my Mom made probably 70 years ago or more. When I was a kid, it had a beautiful ring to it but haven't heard it since. Currently it has a sad "tink" sound to it. The inside "dinger" is not glazed and I don't know how to tell if it's been fired. It's about 4 inches tall and it's bottom diameter is about 3 inches. It's walls are probably 3/16 inches thick. I can see the glaze is very discolored probably by kitchen oils, etc. over time and I'm guessing this is what deadened the ring. Is there any way to put this little dinner bell back to work? Have you checked for cracks in the ringer and the bell? I would think that would have an effect on the sound. Marianne Marianne, I just checked with the naked eye and fingers. The eye's can't tell and it's too rough for the fingers to tell. Thanks, Andy I agree with both Steve and Marianne. Its probably cracked, but its worth keeping just the way it is. If you try to refire it you will almost certainly damage it. I think just value it for its history ) Annemarie OK, but OT, is there some connection between Marianne and Annemarie? The co-incidence is hard not to notice. Thank you for your advice, Andy None what so ever ) I didn't even notice, I just don't think about them being basically the same except reversed. I live in New Zealand and I think (correct me if I'm wrong) Marianne lives in the USA. Cheers Annemarie |
#8
|
|||
|
|||
"annemarie" wrote in
: OK, but OT, is there some connection between Marianne and Annemarie? The co-incidence is hard not to notice. Thank you for your advice, Andy None what so ever ) I didn't even notice, I just don't think about them being basically the same except reversed. I live in New Zealand and I think (correct me if I'm wrong) Marianne lives in the USA. Cheers Annemarie Annemarie, Thanks to you and everybody who helped me out. I'm going to leave the bell as is but keep it on display. If anybody asks me about pottery, ceramics, clay, etc., I'll send them to this newsgroup. All the best, Andy Philadelphia, PA |
#9
|
|||
|
|||
"annemarie" wrote in message ... "Andy" wrote in message 6... OK, but OT, is there some connection between Marianne and Annemarie? The co-incidence is hard not to notice. Thank you for your advice, Andy None what so ever ) I didn't even notice, I just don't think about them being basically the same except reversed. I live in New Zealand and I think (correct me if I'm wrong) Marianne lives in the USA. Hehe! Anne and Marie are common names in so many languages, it is definitely just a coincidence! And - sorry, Annemarie - I am in Switzerland, but Norwegian. I have never lived in USA, but have lived in Canada for a lovely 9 years - once upon a time :-) Marianne |
#10
|
|||
|
|||
"Bubbles" wrote in message ... "annemarie" wrote in message ... "Andy" wrote in message 6... OK, but OT, is there some connection between Marianne and Annemarie? The co-incidence is hard not to notice. Thank you for your advice, Andy None what so ever ) I didn't even notice, I just don't think about them being basically the same except reversed. I live in New Zealand and I think (correct me if I'm wrong) Marianne lives in the USA. Hehe! Anne and Marie are common names in so many languages, it is definitely just a coincidence! And - sorry, Annemarie - I am in Switzerland, but Norwegian. I have never lived in USA, but have lived in Canada for a lovely 9 years - once upon a time :-) Marianne Oh sorry, wrong assumption. Your english is very good. Annemarie and Marianne etc are common names and in many language you are quite right. My niece is living in Canada at the moment and really enjoying it. She has met a lovely man too which is making the place even more attractive. ) I can see its getting time again when we all give a brief bio of ourselves. Its interesting. Annemarie |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help for restoring clay dinner bell ring? | Andy | Polymer Clay | 1 | May 10th 05 10:09 PM |
[Ganoksin] Orchid Members Celebrate Forum's Achievements at Annual Dinner | Ganoksin | Polymer Clay | 0 | March 3rd 05 02:03 AM |
[Ganoksin] The 9th Annual Tucson Orchid Dinner | Ganoksin | Polymer Clay | 0 | January 11th 05 02:57 AM |