|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 31st 05, 05:36 AM
posted to rec.crafts.glass
|
|||
|
|||
Sandblasting glass with lower CFM's and more control
Frosted the edges of my Hotrods mirrors with this...
http://www.PABlaster.com Best part is you can build your own from JUNK in less than a day.. No more pot-blasters, cup-blasters or siphon garbage.. this is a NEW WAY with CONTROL that does not CLOG ! 
|
| Ads |
|
#2
December 31st 05, 11:12 PM
posted to rec.crafts.glass
|
|||
|
|||
|
Sandblasting glass with lower CFM's and more control
In article . com,
"Rob in NH" wrote: http://www.PUBlaster.com I'd think more of this if the guy selling the plans wasn't named Robert or didn't live in New Hampshire. Mike Beede
|
|
#3
January 3rd 06, 02:20 PM
posted to rec.crafts.glass
|
|||
|
|||
|
Sandblasting glass with lower CFM's and more control
Frosted the edges of my Hotrods mirrors with this... http://www.PABlaster.com Best part is you can build your own from JUNK in less than a day.. No more pot-blasters, cup-blasters or siphon garbage.. this is a NEW WAY with CONTROL that does not CLOG ! Above site address is very similar to: www.pabblaster.com Maybe just coincidence?? The PAB Blaster system for glass engravers appears to come highly recommended according to members of http://www.cuttingedgesandcarving.com/forums/index.php Note: I have no connecton whatsoever with PAB Blaster. David --
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
