If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Newbie question
I'm helping a partially blind friend. He has some small pieces of polished
Brazilian quartz he wants to drill a hole into. I have found several suppliers on line that will sell 1/16" and 1/8" diamond bits for reasonable prices, around $15 per. Slightly less when bought in threes. Is this what he needs to drill these holes? I know he needs to use coolant, and set it up in a drill press. Info on what would be the best way to do this appreciated. Steve |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Newbie Question | bessie | Quilting | 4 | November 12th 06 02:33 AM |
Newbie Question | Polymer Clay | 5 | January 10th 05 04:25 PM | |
Newbie Question | Allen Mealer | Polymer Clay | 4 | August 13th 04 07:59 PM |
newbie question | Plissken | Sewing | 8 | May 7th 04 08:01 PM |
newbie question | edie | Yarn | 9 | January 19th 04 02:27 AM |