If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
custom fabricated glass vitrines
We are searching for a source for custom fabrication of rectangular
glass containers, similar to vases. Can this be fabricated as single piece, blown? Sizes range from approx. 3"W x 2"D x 6" H to 6"W x 6" D x 16" H. Multiple units required in approximately 5 different sizes. Optical clarity important, especially so on front (viewing side) of display. Containers will be used to house boiological speimens in preservation solution. Thanks to anyone who can help! You can email me directly at . Mot |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
torch question | Karen_AZ | Beads | 48 | October 1st 04 07:59 AM |
Soldering jump rings with glass | Robin | Jewelry | 9 | September 9th 04 04:41 AM |
AD-Great Lakes States Intergalactic Bead Festival Cleveland, OH December 6-7, 2003 | Phineas T Beadd Director National Bead Society | Beads | 0 | November 20th 03 07:48 PM |
FA: $5.00The Technique of Stained Glass | Elric of Imrryr | Marketplace | 0 | July 30th 03 03:53 AM |
glaze FAQs | Tom Buck | Pottery | 0 | July 18th 03 05:40 AM |