If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Glassman wrote:
"nJb" wrote in message ... I use the kiln sitter as an extra overtemp protection. If you're going to buy a stand alone controller, let me give you a bid. -- Jack How much Jack? I can use one too. Even used is fine. Depends on what you want. A basic 50A 240V built around a CAL9500P 3 button controller would be $650. It will store probably all of your programs. It stores all of mine with room left over. Switching is silent, done by a solid state relay. They are a little more complicated to program than the others on the market but have so many more features. It took me about a week or two before I could drive it without the handbook nearby but after that it's a breeze. Options include redundant over temp protection with a separate TC. http://www.advindsys.com/Cal9500.htm http://www.advindsys.com/Cal/CAL9500PManual.pdf http://pg.photos.yahoo.com/ph/xmissi...ca.jpg&.src=ph -- Jack bobo1148atxmissiondotcom http://photos.yahoo.com/bc/xmissionbobo/ |
Ads |
#12
|
|||
|
|||
|
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need advice/info about kilns for metal clay | Peggy | Beads | 9 | November 10th 04 05:19 PM |
Hi, I have two Alpine Kilns for sale | Sky | Pottery | 0 | June 27th 04 02:09 AM |
DONATE USED KILNS | grizzzlyadam | Pottery | 14 | March 22nd 04 01:58 PM |
LARGE WALK IN KILNS WANTED | grizzzlyadam | Pottery | 0 | March 16th 04 09:44 PM |
newbie question on kilns | Beowulf | Pottery | 14 | January 28th 04 12:31 AM |