If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Is it possible to carve nitroglycerine ? ? ? ? ?
I want to carve nice objects from nitroglycerine.
What should I do? |
Ads |
#2
|
|||
|
|||
|
#3
|
|||
|
|||
Only ONE hammer blow will be necessary.
-- Charley "hue" wrote in message ... On 14 Dec 2004 15:01:10 -0800, (Bruno Beam) wrote: I want to carve nice objects from nitroglycerine. What should I do? The best way for you would be to form it up by striking your material sharply with hammer blows. |
#4
|
|||
|
|||
Be sure to wear suitable ear protection!
"Bruno Beam" wrote in message om... I want to carve nice objects from nitroglycerine. What should I do? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can I carve Thorium ? ? ? ? | Hans-Marc Olsen | Carving | 2 | July 26th 05 12:06 AM |
I carve air ! | Brian Raab | Carving | 0 | October 3rd 04 02:51 AM |
Carve on oak whiskey barrel tops? | kyrustic | Carving | 0 | February 24th 04 12:05 AM |
How to carve bones? | Shane D. Maudiss | Carving | 6 | December 6th 03 04:40 PM |