|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 6th 03, 01:43 PM
|
|||
|
|||
rubbery clay
I baked some very thin pieces of clay, probably 1/16 of an inch thick. I baked
them at 275 for 30 minutes. The items cames out flexible instead of hard. I am using Premo Sculpey polymer clay. What did I do wrong? 
|
| Ads |
|
#2
December 6th 03, 01:47 PM
|
|||
|
|||
|
Quick answer. You didn't do anything wrong. Premo is strong and flexible when thin.
|
|
#3
December 6th 03, 05:04 PM
|
|||
|
|||
|
The items cames out flexible instead of hard. I
am using Premo Sculpey polymer clay. What did I do wrong? You expected it to get too hard, is your only mistake---polymer stay somewhat flexible when thin, and Premo is very much so. Sarajane Sarajane's Polymer Clay Gallery http://www.polyclay.com
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Poly Clay/ wicked Candace | Stephanie | Beads | 49 | September 12th 04 03:07 AM |
| Kato clay... | Louise | Polymer Clay | 4 | November 18th 03 11:37 PM |
| Sculpey Eraser Clay - one year later | Irwin | Polymer Clay | 3 | October 21st 03 09:06 PM |
| Makins and La Doll & other stone ground mineral clays?? | DianeGlassAttic | Polymer Clay | 0 | October 13th 03 06:21 PM |
| Modeling clay as a substitute for "clay bars" for auto detailing? | Jon Noring | Polymer Clay | 4 | September 23rd 03 12:36 AM |
Linear Mode
