If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Looking for faceting belt
Help-I have an old Sapphire faceting machine and the belt is just
about gone. It is a round cloth covered belt is 36 inches in circumference and about 1/4 inch in diameter. I have had little luch in automotive or hardware. Does anyone know where I might get such a belt or have one they no longer want and are willing to sell. THanks for you time. Linda |
Ads |
#2
|
|||
|
|||
I also facet Linda but can only suggest that folks have used O-rings and
'repair' belts (these are temporary automotive belts made for emergency repairs) and sewing machine drive belts as used on old Singers but i think you should subscribe to the ILA and post your question; http://www.gemcutters.org/ Carl 1 Lucky Texan linda wrote: Help-I have an old Sapphire faceting machine and the belt is just about gone. It is a round cloth covered belt is 36 inches in circumference and about 1/4 inch in diameter. I have had little luch in automotive or hardware. Does anyone know where I might get such a belt or have one they no longer want and are willing to sell. THanks for you time. Linda -- to reply, change ( .not) to ( .net) |
#5
|
|||
|
|||
I have a Sapphire Faceting Machine that is missing the Brass Head; I found the Machinest that worked for Arrow Profile yet he said he was up in years and could not make one for me. Could I rent or borrow your brass head so I can have a local mahine shop make it for me?
Thanks Rich Quote:
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Diamond belt sanders for polishing glass | Boner the Cat | Glass | 10 | April 23rd 04 11:42 PM |