If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
New controller!
Hi All,
Today I'm getting my new bartlett vc-6f kiln controller. If anyone here has one and feels like sharing, please pass on anyone tips/recommendations. Thanks, Zander |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problems reconciling controller temp to cone: way over fired! | tony | Pottery | 3 | June 8th 04 10:09 PM |
Advice re Orton or Bartlett Controller | WillMore | Glass | 7 | March 23rd 04 12:16 PM |
Old Kiln Question? | jk | Glass | 16 | November 26th 03 01:59 PM |
Cone question | L.Mac | Pottery | 8 | July 30th 03 01:48 PM |
Kiln controller instructions | Steve & Susan Wright | Beads | 0 | July 21st 03 01:24 PM |