![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
It's nice to see this board again. I use to post here a few years ago,
but drifted away when I moved. I have searched the archives but have some specific questions comparing the Meco Midget & the Little Torch, and how they will work with a wide range of silver fabrication projects. I currently use a smith acetylene/air torch. It has served me well for years. But I now want a torch that has more range at the finer more delicate end for soldering on prongs and other delicate silver work. Many friends and fellow jewelers say get a Little Torch. But my concern with it is that it won't work on my larger hollow formed (but still jewelry) pieces. (If you need visuals my website offers the full range of what I am talking about...www.carlamfox.com) The Meco Midget seems to have the range that could work with the larger silver pieces...but can it also work with the finer/delicate pieces? Then someone suggested the hoses on the Meco may be awkward to use. More awkward then my acetylene/air hose? At this point I am really stuck in the middle of which torch will work the best for my range of projects. Any thoughts would be most appreciated. Thanks. Carla |
Ads |
#2
|
|||
|
|||
![]()
CM Fox wrote:
The Meco Midget seems to have the range that could work with the larger silver pieces...but can it also work with the finer/delicate pieces? No single torch can do everything. A Y manifold (about $20 U.S.) makes you able to run your old torch and the new one. These area available for both fuel and oxygen tanks, so almost any combination is possible. I'm presently running an air-acetylene and an oxy-acetylene Little Torch, using a manifold on just the acetylene tank. -- mbstevens http://www.mbstevens.com |
#3
|
|||
|
|||
![]() Quote:
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
smith torch question/s | Des Bromilow | Jewelry | 2 | September 28th 04 09:09 AM |
Advice regarding soldering equipment | Raane | Jewelry | 4 | February 3rd 04 02:00 AM |