If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Newbie Help
Hello everyone,
My wife has been really getting into making jewelry the last two years, so much so, that she and my daughter are even doing a 'Mother/Daughter' show in December. I'd like to invest in her new found hobby and ramp her up to 'the next level'. To my thinking, this would be giving her the ability to solder/weld/grind/polish silver. Can anyone recommend a book and a 'starter set', whether it exists in kit form or that I have to track down and buy the components. As an example, she is using a Dermal and dental burrs to drill small holes thru Abalone and semi precious stones and then putting silver clasps thru. I know she would like to encase the entire backside and sort of 'frame' the pieces, then have real hoops that have no joints in them. Websites? Resources? I want to give this to her as a Christmas present. Thank you for all the help. Andy Martin Nash, TN |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Intro and newbie question | *~Candygrrl~* | Beads | 26 | September 21st 04 06:04 PM |
Newbie Lampworkers | starlia | Beads | 17 | April 24th 04 01:28 PM |
OT A favor (Should be: Not so Newbie Introduction LOOOOONG) | Carol in SLC | Beads | 104 | August 28th 03 06:25 AM |
RCB FAQ and Newbie Welcome - Weekly Post 8/15/03 | Kandice Seeber | Beads | 1 | August 15th 03 07:57 PM |
Newbie!!! (i admit it, and need all the advice i can get) | C. Gregory | Beads | 7 | July 9th 03 04:31 AM |