If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
foredom micro motor
Help,
I purchased a foredom mirco motor and a gesswin power hand II. It was from ebay and a real bargin. They run. My problem is I don't know how to change the bits. There is a tool with the triangular hole to place over the collet but I can not change the bits because the collet is not held still. After you stop laughing can anyone they me what to do. Thank you, Tom |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Foredom shaft? | John Hofstad-Parkhill | Jewelry | 3 | September 14th 04 02:01 AM |
Need help motorizing a 1963 Schwinn with a DC motor | CapriciousD | General Crafting | 7 | September 5th 04 12:00 AM |
Pen/pencil kits for micro beads - just a thought. | Larry Rubin | Beads | 0 | January 12th 04 03:30 AM |
European/UK source for Foredom tools? | TrevorF | Jewelry | 1 | November 16th 03 10:08 PM |
Pasta motor glitch - reason for worry? | Irwin | Polymer Clay | 0 | November 6th 03 09:58 PM |