![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I accidentally cooked my sculpey at 375 for 20 minutes instead of 275. It's
turned almost black. Question is...I was planning on painting it anyway. Is it salvageable? should I bake it longer at a lower temp? Is it going to be more fragile now? Thanks Tania |
Ads |
#2
|
|||
|
|||
![]()
I was planning on painting it anyway. Is it salvageable? Is it going to be
more fragile now? There are various ways to "salvage" toasted (or totally toasted) polymer items... check this page for details on those: http://www.glassattic.com/polymer/baking.htm (click on "Darkening, Scorching, Burning" then scroll down to "some remedies ..... for burned items") So far no one has mentioned the clay being more fragile after burning, so I'm *asssuming* that it isn't. ....should I bake it longer at a lower temp? ... If you mean next time, I'd say definitely g. If you mean re-baking it after it's already burned, I don't think there would be any advantage I know of for that unless you added liquid clay or something else that would need a brief rebaking. HTH, Diane B. http://www.glassattic.com ...... polymer clay "encyclopedia" ..........(for sending e-mail, DO NOT USE this AOL address or I may never see it! --use this address instead: )................ .. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Burnt Out | Harry | Beads | 5 | March 19th 04 07:24 AM |
AD: earrings made out of sculpey | glennda | Polymer Clay | 0 | November 26th 03 08:22 PM |
Blending Premo & Sculpey III | Shannon | Polymer Clay | 1 | November 21st 03 04:48 AM |
Sculpey Eraser Clay - one year later | Irwin | Polymer Clay | 3 | October 21st 03 09:06 PM |
Could "Sculpey" poly clay form part of a waterblock? | Ken Maltby | Polymer Clay | 1 | August 13th 03 01:48 PM |