"tiffsgames" wrote in message
lkaboutcrafting.com...
Okay, I threaded the bobbin just fine. I even managed to raise the thred,
I
just can't seem to follow their directions to get the bobbin threrd to
"flow" it keeps breaking. I know it's not a tension issue. I'm not
stairing at the book right now but I believe it says to go under slot 1
and over slot 2 then pull thread tail to back; which I did 100x.
Apparently I'm slow or something (of course my last machine was a late
70's model). Please someone walk me through this, I even tried Youtube and
found a video that would have been helpful had it not had bad lighting.
(Please excuse typos my keys are sticking).

--
Message posted using
http://www.talkaboutcrafting.com/gro...xtiles.sewing/
More information at http://www.talkaboutcrafting.com/faq.html



That model has the one way bobbins. Are you using the bobbins that came with
the machine? I can't imagine how you could get it in wrong but if it is
difficult to insert, it should just fall in. Then perhaps turning the other
way around.

--
Ron Anderson A1 Sewing Machine
18 Dingman Rd Sand Lake, NY 12153
http://www.a1sewingmachine.com