Question from the past====
Just a question from past experience.
I was (I thought) lucky to get one of the Technicolor Irons during our
discussion here last April
Wondered if anyone else has had a problem.
Turned mine on and thought I must have gotten some starch on it, so
got a fabric softener sheet to clean it off. Well,,, the softener
sheet melted on contact, and that's after I had let it cool a bit.
I am sure it is a hot spot, but before I write the manufacturer, I
thought I would see if anyone else has had trouble.
I did have it plugged into a surge protector (engineer dh) and never
left it on any longer than necessary since it made my sewing room heat
up-that stuff happens in Florida.
Any advice or comments????
Anna Belle in Palm Bay
|