Silver supplier question
On May 21, 6:55=A0pm, "Paul K. Dickman" wrote:
I have a question that the group may be able to answer.
I am currently pricing a commission for a fairly complex set of Shabbat
candlesticks. It is still in the design by committee stage, but it involve=
s
hammered silver reflectors.
Originally the reflectors were a series of curved plates 3"x10".
In as much as maintaining reflectivity was important. I suggested using
Argentium silver. With such a =A0high silver price, the premium is a much
smaller percentage of the cost and it seemed like an ideal application.
Then the designed changed. The reflectors were now a few plates 6"x10".
"No problem", I sez, "I can use standard 6" wide Argentium sheets".
Now that the customers are all hyped up on Argentium, they decide they wan=
t
the reflectors 8"x10".
My question is:
Does any know if someone is producing Argentium sheets in wider widths?
Preferably here in the states.
There are some creases in the reflectors where I can hide a seam, if I hav=
e
to, but I would really rather not have to solder 2-8" joints in each panel=
..
Paul K. Dickman
Paul:
Why not just buy a heavier gauge argentium sheet, if you can find
somebody with a wide-enough mill to roll it to size for you? That
would certainly be easiest. You might even get one of the current
suppliers of Argentium to do it on a contract basis.
Or if your reflectors are curved surfaces, stretch the sheet on an
english wheel. Last resort would be to forge it out yourself --
doable, but tedious in that size -- might be a little easier with a
sand bag and sheet-metal style panel beaters, though.
Regards,
Bob
|