Possibly not the same power requirement, hobby lathe might be OK.
I admit, he seems to need to do longer pieces than might be practical to
cast though. And certainly they wouldn't have comparable
finish/precision, etc.
Just a thought.
Carl
Abrasha wrote:
Carl 1 Lucky Texan wrote:
Like Peter said, plus, if the piece were not too large, perhaps it could
be done in wax and then cast?
Carl
To cut a helix in wax you would need the exact same setup as for metal.
Abrasha
http://www.abrasha.com
--
to reply, change ( .not) to ( .net)