HI Mike
On Tue, 12 Feb 2008 13:07:11 -0000, "M"
wrote:
"charlie" wrote in message
...
"Lauri Levanto" wrote in message
...
M wrote:
I have a good few lumps of old broken glass some up to about 3" thick
and
would like to cut thin sections out but not sure if or how it can be
done.
If it can would it be expensive and what percentage woulod be wasted
roughly. Who if anyone does that type of work. What thickness would be
the
best to aim for.
It is pieces of a broken lighthouse fresnel lens which we would like in
slivers/sections so that a picture of the lighthouse could be etched
onto
them.
Sorry there are som amny questions but hopefully someone may have the
answers.
Thanks Mick
Do I understand right that you want to cut the curved fresnell pieces
radially, to get say ½" slices withthe three polished sides intact.
Interesting job.
How thick are the fresnedd segments. A tile saw may reach 1½"deep
lapidary saws a little deeper. Large blades are thick to prevent
vibration.
What you need is to get together
1. A glass artist with that kind of experience of cold working
with wet belt sanders and plishing planes.
2. A gravestone maker with proper saws.
The etching then is easily found.
-lauri
a normal 10" tile saw will cut these ok. you can cut up to about 4" thick.
it won't be polished, which will take normal glass polishing techniques.
someone with a flat lap or vibrolap could do that.
Thanks for the advice and I think I'll go with the 1/4" thick and get it
polished. These are like big rough pebbles mostly and came from the lens
being smashed on the rocks when being replaced years ago. I keep finding
lumps and have given a good few away to visitors who have an interest in
lighthouses or this location. Just thought if not too expensive it would be
nice to be able to give them a piece engraved by a local artist.
Thanks again to all for the advice and I am taking some down on holiday with
me in a few weeks and will try to locates a firm in the
Yorkshire/lancashir/Cheshire area that can do the job.
Mike
Ah - you didn't say you were in the UK ! g
Have a word with Andy at
http://www.agatehouse.co.uk
Nice bloke, did some cutting / polishing for a neighbour of mine when
I lived back in the UK.
I've only got a small lap saw at the moment, so can't help you
myself... sorry...
Hope this helps
Adrian
www.inspired-glass.com