View Single Post
  #1  
Old July 5th 06, 05:39 PM posted to rec.crafts.textiles.yarn
external usenet poster
 
Posts: n/a
Default materials for knittng sheaths

Earlier, I posted that I did not like ash for knitting sheaths. Now, I
have recarved the goose wing prototype that I made from an ax handle. While
the ash, particularly in cross grain, is NOT smooth enough for a yarn
contact material, the friction generated by the textured surface does a very
good job of holding the sheath motionless when tucked under a heavy leather
belt. This allows the use of looser or softer belting. I have decided that
I like the ash so much that I just cut a blank out of ash for a knitting
sheath dedicated to # 0 and #00 needles.

I have also started using brass tubing to line the holes that hold the
knitting needles. Knitting needles made of music wire fit snugly and
smoothly into standard brass tubing, also available at hardware stores. A
bit of hot glue in the bottom of the brass tube protects the points and
provides just a bit of adhesion to keep the needle from slipping out.
(This may not work in the long run, but the first 2 days are pretty good.)

I knit ~ 2000 stitches last night after the fireworks, that is worsted
weight yarn knit at 8 spi. I could never do that with cable needles, at
least not without stressing my wrists.

Aaron


Ads