I've done it quite a few times. The overall size of the panel should
somewhat dictate the thickness of the float, and if it is going to be
installed in a door or over a bathtub, the sheet glass must be tempered.
Remember that the overall finished size of the IGU (insulated glass unit)
will be 1/2 to 3/4" bigger than your art glass panel because of the
spacer/dessicant/sealant. The two pieces of float are sealed together, and
the art panel just "floats" in the cavity.

"Adrian" wrote in message
...
HI Folks

I've been asked about providing some 'double-glazed' units with my
tiffany-style, copper-foiled, panels 'sandwiched' in-between.

The local glazing company is very happy to do the 'sandwiching - reckons
that he'll use two thin spacers between the float glass, and center my
panel that way.

I understand that the finished effect won't be quite the same as seeing a
'raw' panel - but, as I say, customers have asked...

I was planning on geting a small sample panel made up - before I do this
does anybody have any comments, suggestions, or experiences?

Thanks
Adrian - West Cork, Ireland
www.inspired-glass.com