Do you have a garage? Having it outside could be a problem, the colder
temperatures could make it more difficult to reach your required temp. You
would be using much more electricity and even bunged it is making your kiln
work a lot harder. I am in New Zealand and have my kiln in my garage and
even here (moderate climate) I notice the kiln takes longer on a cold 10C
winters day. I close the garage doors and it does make a difference. Yes I
am in Wellington and wind is an issue sometimes.
Could you build a small shed to house it? Here in NZ anyway small garden
sheds are pretty cheap.
Good luck
Annemarie

"Charles Spitzer" wrote in message
...

wrote in message
.. .
Hello all,
I've read similar postings over the past few years, but I guess I didn't
pay
attention to the answers well enough. I've got a kiln that I can't get
into
my house. It's been on my front porch wrapped in plastic, lowering
property
values for a year now, becasue I'm not sure what to do. I could get it
into
my back porch and I'm trying to figure out the feasibility of putting it
there.

First, the back porch is a wooden structure, about 8 feet wide and 5
feet
deep, with the adjoining wall to the house being made of brick. I could
run
the wiring through to this wall. The advantage, is of course that
venting
would be easy, it's not actually in the house. Disadvantages, this is
Canada and it regularly goes to -20 or -30 in the winter. So, how
realistic
is this, what kind of insulation would be required to deal with the fact
that it's made of wood, what kind of clearance from wooden walls is
needed
to keep it safe? etc.

about 18" seperation. you could put up durock (cement board) to protect
it.
don't forget the floor.

I know people have commented on similar questions in the past and I'm
wondering if you'd mind repeating your advice! Thanks in advance.
Simon