On Mon, 9 Jun 2008 02:30:34 -0700 (PDT), Gap
wrote:
Bob and Donna,
thanks for all your input!
It is not a problem to make the parting line exactly at half of the
ball because they do come in 2 halves.
I also thought it is because of the porosity of the polystyrene which
is tini balls melted together and I
understand what you mean with undercut.
That is probably not a good surface finish to start with..
I have asked my pottery teacher in Germany who has made a lot of these
balls and he said clay slip would be also a good medium for
separation, so I might try that..
Someone else said I should put gladwrap over the balls before I put
the plaster on. That would make the surface smooth but would give me
lines where the gladwrap is "folded".
I have also thought about painting the ball with some paint or even
fluid latex which I have here.
I guess I just have to try different things and see which works best.
Thanks again hand happy pottering and/or mould making!
Cheers from Gabi
Clay slip is a good idea, if it will stick to the balls. I often use
no parting compounds at all when casting objects made of soft clay,
since the clay can be deformed a bit if needed to release it.
Best regards,
Bob Masta
DAQARTA v3.50
Data AcQuisition And Real-Time Analysis
www.daqarta.com
Scope, Spectrum, Spectrogram, FREE Signal Generator
Science with your sound card!