View Single Post
  #5  
Old October 17th 05, 08:46 AM
spinninglilac
external usenet poster
 
Posts: n/a
Default Dorset crosswheel button instructions

As I said to Katherine, Gems, they are somewhat fiddly to do for the first
time. So you need some time to start going with them. Get larger rings and
work with yarn to start with just to get the idea.
Cheers.....Cher


"MRH" mthecarpenterATxcelcoDOTonDOTca wrote in message
...
Grabbed and saved for another time. Thank you, Cher! )

Gem

"spinninglilac" wrote in message
...
Found this on the net if anyone is interested and wants to try it out.
This
says to make them with Linen thread, but we make them out of yarn,

adding
beads to the spokes etc..Bit of history then how to do
them...Cheers...Cher

Here is a variation in the directions:
From The Lady's Guide to Plain Sewing, Book II:

The buttons usually used for shirts and personal linen were thread
buttons.
A well organized cottage industry, begun in 1622, in Dorset, England,

gave
rise to the name of numerous styles, including the Dorset Crosswheel.
First
bone discs then metal rings were used to make many of the buttons. They
should be made without a break in the ring, such as those used for Roman
shades and curtains. Those of 3/8 inch inside diameter are a good size.

To make a dorset crosswheel button, a linen thread of 40/2 or a similar
size, usually bleached, is used to stitch the buttons. You will need a
piece
at least two yards long for each button.

The first step is called casting: using a small, blunt needle, make
buttonhole stitches all around the ring, spacing the stitches very
closely,
and completely covering the ring. The knots, or pearls, of the stitches,
will lay to the outside of the ring.

The second step is called slicking: twist the buttonhole stitches around
the
ring, so that the knots, or pearls, are on the inside of the ring. Use

the
needle to catch some of the pearls, and begin the twisting with a lever
like
action. After the twisting is started, it is usually quite easy to

finish
the slicking with the fingers.

The third step is called laying: holding the ring firmly with the

fingers
of
one hand, and the thread pulled taunt by the other, wrap the thread

around
the ring, making "spokes". Usually, tweleve spokes are made. With your
imagination, divide the ring like the numbers on a clock. The thread

must
be
held taunt to prevent the spokes from loosening and falling off the

ring.
The centers will not cross exactly at this stage. Complete this step by
securing the threads to the center with a couple of crosses stitches,
catching all of the spokes. The first crossd stitches can be adjusted to
the
center using the needle to push the stitches. Cross the centers again.
Check
to be sure the crossed stitches are in the middle of the ring. This is
very
important!

The fourth step is called rounding: using the needle, weave around from
spoke to spoke, taking a stitch under and back over each spoke (like a
backstitch). Work from the center outward, fillin in the ring as closely
as
possible. Keeo your work even and neat.

Finish the button by using a sharp needle to run the remaining thread

tail
through the back of the rounding and exit at the center back of the
button.
The tail may be left to use to set on the button, or may be trimmed off.

End text.







Ads