PANEL and DOME shade makers...need an opinion
I have developed a workable, easy to use and set up jig (or fixture) that
will enable one to level and solder panel lamps and small domes. the shade can be leveled on a rod and held in place thus freeing BOTH HANDS. only 23 years of experience and about 1,050 or so shades of all sizes..... If I can find a market for this, I could easily go into production on an "on demand basis" if you are a shade maker....feel free to reply here; TIA HOWARD -- In the words of the IMMORTAL USED CAR DEALER: THERE IS AN ASS FOR EVERY SEAT! |
Could you post photo of same (somewhere)?
"Howard" wrote in message ... I have developed a workable, easy to use and set up jig (or fixture) that will enable one to level and solder panel lamps and small domes. the shade can be leveled on a rod and held in place thus freeing BOTH HANDS. only 23 years of experience and about 1,050 or so shades of all sizes..... If I can find a market for this, I could easily go into production on an "on demand basis" if you are a shade maker....feel free to reply here; TIA HOWARD -- In the words of the IMMORTAL USED CAR DEALER: THERE IS AN ASS FOR EVERY SEAT! |
Randy Wardell, in one or some of his books, has a simple to build jug
that works great. I built one so can attest to the fact that it works just fine. total cost to build is under $5.00. Andy "Moonraker" wrote in message ... Could you post photo of same (somewhere)? "Howard" wrote in message ... I have developed a workable, easy to use and set up jig (or fixture) that will enable one to level and solder panel lamps and small domes. the shade can be leveled on a rod and held in place thus freeing BOTH HANDS. only 23 years of experience and about 1,050 or so shades of all sizes..... If I can find a market for this, I could easily go into production on an "on demand basis" if you are a shade maker....feel free to reply here; TIA HOWARD -- In the words of the IMMORTAL USED CAR DEALER: THERE IS AN ASS FOR EVERY SEAT! |
All times are GMT +1. The time now is 09:40 PM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
CraftBanter.com